PROMAT CHEMICALS High-performance cutting oil 5 l

Not miscible with water
– For high-speed metal chip removal machining processes with non-ferrous metals and soft to hard and tough steels at high cutting speeds and increased cooling/flushing property requirements (reaming, deep drilling, high-speed turning, etc.)
– Inhibits non-ferrous metals, i.e. non-copper corrosive, free from zinc, chlorine and silicone
– High wear protection due to balanced EP additives
– Low-evaporation base oil (therefore only slight oil mist formation)
– Very good heat dissipation and distinct wetting and flushing behaviour generate high surface qualities
– Density at +15 °C: 885 kg/ m³
– ISO 3675
– Viscosity at +40 °C: 30 mm²/s ISO 3104
– Viscosity at +100 °C: 4.8 mm²/s (ISO 3104)
– Flash point (COC): >+200 °C ISO 2592
– Corrosive effect on copper 3 h/+100 °C: 1a (degree of corrosion) EN ISO 2160
– Silicone-free Further technical information:
– Material suitability: Non-ferrous metals, steel